Boot camp tasks Electronics Solder USB connector with hot air Solder 2 mm bullet connectors to motor wires. Attach Micro-MaTch connector to motor encoder wires. Test mainboard with a power supply and a motor Send commands to mainboard with HTerm Mechanics Install Fusion 360 Model a minimal motor mount Assemble a motor with the motor mount 3D print Drill over a 2.5mm hole and cut an M3 thread Connect motor to motor mount with correct length M3 screws Attach motor with mount to test robot Software Setup Send commands to mainboard to rotate motors Simulate rotating towards a ball with PrintingMotion Rotate towards the ball with the test robot Changelog 2022-09-01 Created Electronics guide documents Created Mechanics guide documents Created Software guide documents 2022-09-03 Removed Python 3.9 requirements for the Software guide Modified Software guide to not include omnimotion and just include rotating towards the ball