PiCR Docs

PiCR

    • Grading and tasks
    • GitLab (team repository) guide
  • Basketball robot guide
    • General
      • Using batteries
    • Electronics
      • Test robot
      • Components
      • Altium Designer
      • Schematic
      • PCB layout
      • Firmware
      • Review summary
    • Mechanics
      • Design
      • Checklist
      • Fusion 360 CAM
      • Review summary
    • Software
      • Omni-motion
      • Remote desktop setup
      • Using IDE plugins
      • Review summary
  • Boot camp tasks
    • Electronics
      • Solder USB connector with hot air
      • Solder wires with 2mm bullet connector to PCB
      • Test mainboard with a power supply and a motor
      • Send commands to mainboard with HTerm
    • Mechanics
      • Install Fusion 360
      • Model a minimal motor mount
      • Assemble a motor with the motor mount
      • 3D print
      • Drill over a 2.5mm hole and cut an M3 thread
      • Connect motor to motor mount with correct length M3 screws
      • Attach motor with mount to test robot
    • Software
      • Setup
      • Send commands to mainboard to rotate motors
      • Simulate rotating towards a ball with PrintingMotion
      • Rotate towards the ball with the test robot
PiCR 2024
  • PiCR
    • 2024
  • PiCR
  • Boot camp tasks
  • Mechanics
  • Install Fusion 360
Edit this Page

Install Fusion 360

Standalone software (only Windows & Mac users)

  1. Go to https://manage.autodesk.com/products

  2. Log in when prompted.

  3. Select "Download" under "Fusion 360".

Fusion 360 in browser (better for users who are unable to install standalone program)

  1. Go to https://fusion.online.autodesk.com/ and follow the instructions and log in when prompted.

This page was built using the Antora default UI.

The source code for this UI is licensed under the terms of the MPL-2.0 license.